Canopy Emergency Release

Created removable hinge pins from piano wire to allow someone to open the canopy from the outside in case of emergency.

Fuel Gauge Marking & Flow Test

Ordered up some fuel delivery and marked the tanks in 5Gal increments.  Performed all the fuel flow tests to ensure adequate fuel delivery.

Cowl Heat Shield

Used adhesive backed foil for heat shields on the cowl where the exhaust pipes run.  Used an added layer of fiberfrax where the clearance was less than 1/2".

Cowling Primer

Primed up the cowl and misc. pieces.

Oil Access Door

Cutout oil access door and laid up lips for door in upper cowl.

Vortilons

Made the vortilons.  Cut the initial shapes out of 4-ply bid, so the final product ended up a little fat, but it'll work.

Cowling Finishing

Went through the drudgery of applying wet micro, sanding, and repeating until the cowl was smooth. Spent the time on the upper cowl, but did the bare minimum on the lower as I expect it may change in the not do distant future.